MisterBest MisterBest

Everyday

How do I find the low spot in my floor?

Roll a marble. Release it from at least three points across a cleared hard floor and mark each resting spot with tape. Discard any marble that stops against a wall, baseboard or furniture, since that shows slope rather than a dip. Where two or more marks land within a hand's width in open floor is the likely low spot.

How to do it

  1. Clear the room and check the floor surfaceMove rugs and loose items out of the way. The test needs a hard, smooth surface such as hardwood, tile, vinyl or laminate.
  2. Release a marble from at least three pointsSet the marble down gently without pushing it, from spots spread across the room, and wait until it comes to a full stop.
  3. Mark each resting spot with tapePut a strip of painter's tape where each marble stops, so the marks stay in place after you pick the marble up.
  4. Discount marbles stopped by an obstacleCross out any mark against a wall, baseboard or furniture. That marble was blocked, so it shows the direction of a slope, not a dip.
  5. Read the clusterWhere the marks bunch up in open floor is the likely low spot. Check that area before you tile, level or place heavy furniture.

Questions that come up

Does the marble test work on carpet?

No. Carpet and rugs create too much friction, so the marble stops wherever it runs out of speed rather than where the floor is lowest. Use it on hardwood, tile, vinyl, laminate or bare concrete. For a carpeted room, a long level or a laser level is the better tool.

What if every marble rolls to the same wall?

Then the floor most likely slopes in that direction instead of dipping in one spot. That is common in older homes and is a different problem. A marble can show you which way the floor tilts, but you need a level or a straightedge to measure how much.

How big a dip can a marble detect?

A marble can roll on a very slight slope, so it may flag dips too small to matter. It tells you where to look, not how deep the dip is. Before tiling or installing flooring, check the marked area with a long straightedge and measure the gap underneath it.

Should I worry if I find a low spot?

Not necessarily. Small dips are common and usually only matter for tile, floating floors or furniture that wobbles. A dip that keeps growing, or that comes with cracks, bouncy spots or sticking doors, is worth having a contractor or structural engineer look at.

Full transcript

Find your floor's low spot with a marble. Release marbles from a few spots, then tape where each stops. Ignore any that stop at a wall or baseboard: that's slope, not a dip. Where the marks bunch up mid-room is your likely low spot.

Last updated