MisterBest MisterBest

Everyday

How do I find a stud without a stud finder?

Slide a strong neodymium magnet across the wall until it snaps and holds: that is usually a drywall screw in a stud. Slide up 12 inches to find a second screw and confirm the vertical line. Check for live wires, then drill a pilot hole an inch above the screw; pale wood curls, not white dust, confirm the stud.

How to do it

  1. Slide a strong magnet slowly across the wallUse a small neodymium magnet and wrap it in a thin cloth so it doesn't scuff the paint. Move it sideways slowly, at about light-switch height.
  2. Mark the exact screw spot where the magnet snaps and holdsStick a short horizontal strip of painter's tape centred over the spot and put a pencil dot exactly on the screw. A magnet that holds on its own has usually found a drywall screw or nail fixed into a stud.
  3. Find a second screw directly above and join the dotsSlide the magnet straight up about a foot until it grabs again, then mark it the same way. Join the two dots with a level and pencil. Two hits on one vertical line confirm the stud; a lone hit off the line may be a stray fastener.
  4. Check for live wires before drillingSweep the line with a non-contact voltage tester. Take extra care directly above or below outlets and switches, where cables often run along the stud.
  5. Drill a pilot hole an inch above or below the screwStay on the pencil line and never drill into the screw itself. Pale wood curls mean you hit the stud. Fine white dust and a sudden give mean hollow drywall.

Questions that come up

Does this work on old plaster and lath walls?

Sometimes, but it's slower. Plaster walls are nailed to horizontal wood lath, so the magnet finds nails at many heights, and thick plaster weakens the pull. Look for nails that line up vertically every 16 inches or so. Confirm with a small pilot hole before trusting the spot.

What if the magnet sticks all the way along the line?

You probably have steel studs, which are common in commercial buildings and in some homes. The pilot hole will turn up metal instead of wood curls. Wood screws won't hold well in steel, so use anchors rated for metal studs or for hollow walls.

How strong does the magnet need to be?

A small neodymium magnet about half an inch across is usually enough and costs a few dollars. Ordinary fridge magnets are usually too weak to feel a screw through half an inch of drywall. Keep strong magnets away from phones, cards and young children.

Why not drill right where the screw is?

The bit would hit the steel screw, skid off and could be ruined. Drilling an inch above or below on the same vertical line still lands in the same stud, and you avoid the existing fastener.

Full transcript

No stud finder? Slide a magnet along the wall. When it snaps and holds, it found a drywall screw. The stud's usually behind it. Slide up. A second screw above confirms the line. Check for cables, then drill an inch above the screw. Pale wood curls? That's the stud.

Last updated